Volume 8, Issue 2, April 2020, Page: 47-63
Power System Stability Improvement of Ghana’s Generation and Transmission System Using FACTS Devices
Lawrence Aikins, Engineering and Maintenance Department, Takoradi Thermal Power Plant 2, Takoradi, Ghana
Christian Kwaku Amuzuvi, Department of Renewable Energy Engineering, University of Mines and Technology, Tarkwa, Ghana
Received: May 5, 2020;       Accepted: Jun. 9, 2020;       Published: Jun. 20, 2020
DOI: 10.11648/j.jeee.20200802.12      View  37      Downloads  36
Abstract
Power system stability is a major challenge in the secured operation of today’s interconnected power systems. Voltage stability as a branch of power system stability, is a major problem facing power systems in Ghana. The power system is subjected to major blackouts or collapses due to voltage instability. It is manifested by several distinguishing features: low system voltage profiles, heavy reactive line flows, inadequate reactive support, and heavily loaded power systems. Voltage stability depends on the ability of a power system to maintain acceptable voltage for system buses under normal conditions, and system disturbances. This paper evaluates the steady-state voltage stability of the power system through modelling and simulation using the Power System Simulator for Engineering power system analysis software and the results validated with MATPOWER. Load flow simulations using the Newton Raphson method under steady-state base load condition with and without contingencies were done. Simulation results revealed under normal, and contingency cases show the power system has voltage profile, that violates the voltage stability constraint of between 0.95 pu and 1.05 pu for normal system voltage, high transmission system losses and heavy congestion. The Flexible Alternative Current Transmission System (FACTS) devices was used to improve the power system stability. Three types of FACTS devices: SVC, STATCOM, and TCSC are selected and optimally placed in the power system to improve voltage stability. Generic algorithm as artificial intelligence-based method was used in MATLAB environment to optimally size and locate five (5) FACTS devices; one (1) STATCOM and four (4) SVC in the power system. The algorithm was found to be reliable as it yielded good results by the improvement in voltage stability and decreasing the transmission line active and reactive power losses significantly.
Keywords
Flexible Alternative Current Transmission System, Genetic Algorithm, Voltage Stability
To cite this article
Lawrence Aikins, Christian Kwaku Amuzuvi, Power System Stability Improvement of Ghana’s Generation and Transmission System Using FACTS Devices, Journal of Electrical and Electronic Engineering. Vol. 8, No. 2, 2020, pp. 47-63. doi: 10.11648/j.jeee.20200802.12
Copyright
Copyright © 2020 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Reference
[1]
Kundur, P.; Paserba, J.; Ajjarapu, V.; Andersson, G.; Bose, A.; Canizares, C.; Hatziargyriou, N.; Hill, D.; Stankovic, A.; Taylor, C.; Van Cutsem, T. and Vittal, V. (2004) “Definition and classification of power system stability IEEE/CIGRE joint task force on stability terms and definitions,” IEEE Transactions on Power Systems, Vol. 19, No. 3, pp. 1387-1401.
[2]
Savulescu, S. C. (2009), “Real-Time Stability Assessment in Modern Power System Control Centers”, pp 413, John Wiley and Sons, Inc., Hoboken, New Jersey, ISBN 978-0470-23330-6.
[3]
Hou, K., Shao, G., Wang, H. (2018). Research on practical power system stability analysis algorithm based on modified SVM. Prot Control Mod Power Syst 3, 11. https://doi.org/10.1186/s41601-018-0086-0.
[4]
Iyambo, P. K., Tzoneva, R. (2007), “Transient stability analysis of the IEEE 14-bus electric power system,” AFRICON, pp. 1-9.
[5]
Abdelaziz, A. Y., Ibrahim, A. M. and Hasan, Z. G. (2013), “Transient stability analysis with equal-area criterion for out of step detection using phasor measurement units”, International Journal of Engineering, Science and Technology, Vol. 5, No. 1, pp. 1-17.
[6]
ONI, Oluwafemi Emmanuel; MBANGULA, Kamati I.; DAVIDSON, Innocent E. (2016). Dynamic Voltage Stability Studies using a Modified IEEE 30-Bus System. Transactions on Environment and Electrical Engineering, [S.l.], v. 1, n. 3, pp. 41-49, ISSN 2450-5730.
[7]
Hasani, M. and Parniani, M. (2005), “Method of Combined Static and Dynamic Analysis of Voltage Collapse in Voltage Stability Assessment,” IEEE/PES Transmission and Distribution Conference and Exhibition: Asia and Pacific, pp. 1-6.
[8]
Acha, E., Fuerte, C. R., Pe´rez, H. A. and Camacho, C. A. (2004), “FACTS Modelling and Simulation in Power Networks”, pp. 9-12, John Wiley & Sons Ltd, West Sussex.
[9]
Hingorani, N. G. and Gyugyi, L. (2000), “UNDERSTANDING FACTS: Concept and Technology of Flexible AC Transmission Systems” Wiley- IEEE Press, 452pp.
[10]
Suman Bhowmick (2018), “Flexible AC Transmission Systems (FACTS): Newton Power-Flow Modeling of Voltage-Sourced Converter-Based Controllers”, pp 291, CRC Press, ISBN 1498756212, 9781498756211
[11]
Uzochukwuamaka Okeke, T. and Zaher, R. G. (2013), “Flexible AC Transmission Systems (FACTS)”, International Conference on New Concepts in Smart Cities: Fostering Public and Private Alliances (SmartMILE), pp. 1-4.
[12]
Ghahremani, E. and Kamwa, I. (2013), “Optimal placement of multiple-type FACTS devices to maximize power system loadability using a generic graphical user interface” IEEE Transactions on Power Systems, Vol. 28, No. 2, pp. 764-778.
[13]
Ghahremani, E. and Kamwa, I. (2014), “Analysing the effects of different types of FACTS devices on the steady-state performance of the Hydro-Québec network”, IET Generation, Transmission & Distribution, Vol. 8, No. 2, pp. 233-249.
[14]
Sirjani, R., Mohamed, A. and Shareef, H. (2013), “Comparative study of effectiveness of different VAR compensation devices in large-scale power networks”, Journal of Central South University, Vol. 20, No. 3, pp. 715-723.
[15]
Mahdad, B., Bouktir, T. and Srairi, K. (2007), “Methodology Based in Practical Fuzzy Rules Coordinated with Asymmetric Dynamic Compensation Applied to the Unbalanced Distribution Network”, International Review of Electrical Engineering (IREE), Vol. 3, No. 2, pp. 145-153.
[16]
Galloway, S. J., Elders, I. M., Burt, G. M. and Sookananta, B. (2009), “Optimal flexible alternative current transmission system device allocation under system fluctuations due to demand and renewable generation,” IET Generation, Transmission & Distribution, Vol. 4, No. 6, pp. 725-735.
[17]
Sookananta, B., Galloway, S., Burt, Graeme M. and McDonald, J. R. (2006), “The Placement of Facts Devices in Modern Electrical Network”, Proceedings of the 41st International Universities Power Engineering Conference, Vol. 2, No., pp. 780-784.
[18]
Hussain, M. H., Musirin, I. Rahim, S. R. A., Abidin, A. F. (2013), “Computational Intelligence Based Technique in Optimal Overcurrent Relay Coordination: A Review”, The International Journal of Engineering and Science (IJES), Vol. 2, No. 1, pp. 1-9.
[19]
Aghaei, J., Gitizadeh, M. and Kaji, M. (2012), “Placement and Operation Strategy of FACTS Devices using optimal continuous power flow”, Scientia Iranica Transactions D: Computer Science &Engineering and Electrical Engineering, Vol. 19, No. 6, pp. 1683-1690.
[20]
Zimmerman, R. D., Murillo-Sánchez, C. E. and Thomas, R. J. (2011), “MATPOWER: Steady-State Operations, Planning and Analysis Tools for Power Systems Research and Education”, IEEE Transactions on Power Systems, Vol. 26, No. 1, pp. 12-19.
Browse journals by subject